How to lay a Self Binding Gravel path....
What is Self Binding Gravel?
Self Binding Gravel is a blend of either 10mm or 8mm sized gravel particles, gravel dust, sand and clay that binds firmly when compacted.
Not only does it look neat and attractive but it's also easy to maintain - just requiring the odd bit of weeding. This makes it perfect for car parks, paths, golf courses, cycle paths, bridleways and larger walkways such as at stately homes and heritage properties.
How to lay a Self Binding Gravel path...
- Digging Spade.
- Vibrating roller or whacker plate. Alternatively use a plank of wood and sledge hammer.
- Dandy's Crusherrun Hardcore (MOT type 1).
- Dandy's Golden Hoggin 10mm or Firechip Red 8mm Self Binding Gravel.
- Hose pipe, watering can or sprinkler.
- Edging stones, sleepers or metal edging.
- Once you have decided where you want your path to run, mark out the edges with a spade edge, some chalk or sand.
- Dig out the area to approximately 15 to 20cm (6 to 8inches) deep. This allows room for at least 10cm (4 inches) of Crusherrun and 5 to 10cm (2 to 4 inches) of Self Binding Gravel. This is just a basic guide though, you can change these to suit your needs but we advise these as a minimum.
- Once dug out the path can then be edged using sleepers, edging stones or edging sheets (metal that can be bent into place - so best if you are using on a curved path!).
- Along the bottom of the path, lay our your layer of Crusherrun - this is so that the water can drain away whilst also creating a firm base.
- On top of the crusherrun hardcore your Self Binding Gravel can be added. Make sure that about 2 to 3cm (1 inches) is above ground level. This will enable it to be compacted down with the vibrating roller but keep the final level where you want it. If you have high sides, such as with sleepers, then simply allow an extra inch to allow for compaction.
- Use the vibrating roller or whacker plate to level the Hoggin or Firechip to the height you desire, sprinkling a tiny amount of water as you go - you can also use a plank of wood placed across the path and hit with a sledge hammer.
- We advise making sure there is an ever so slight camber so that water will drain to the sides and away, instead of pooling in the middle of your new path during heavy rain.
- Voila! Stand back admire your work...